SSS/CZ Design Clean Line Stack set

Hello hello crafty friends.  Thanks for stopping by.  Today I will be sharing how I made a simple card using Simon Says Stamp products from their new release Good Luck Charm.  Let’s get started.

I started with an A2 panel using Neenah Solar white 110lb cardstock.  I sprayed some Pixie spay on my SSS Radiating Squares stencil (one layer) and attached it to my panel.

I grabbed my SSS blending brush and some Lemonade ink and applied a layer of ink.  Then I added another layer of stencil and used a heavier hand of Lemonade ink.  Switched stencil again and applied some Marine and them switched and added Sprout.  (when finished ink blending, clean your stencils off ASAP)

I got some SSS Black cardstock and treated for embossing.  Inked up the sentiment from my CZ Design Clean Line (in my Misti) and stamped my image on my cardstock.  Applied some white embossing powder, shook off the excess and then heat set it.  I ran my sentiment through my die cutting machine with the coordinating die.

Trim down some SSS Silver Holographic cardstock and attach it on an A2 size card base using Neenah Solar white 80lb cardstock. Assemble the rest of the card using foam tape  and finish it off with some embellishments.

That’s it!  Not too hard, right?!?  The products I used for this card and where you can purchase them are listed below. At no extra charge to you for using the list, you can click on them and go shopping. Thank you so much for stopping by and I’ll see you next time.